Rigol MSO5000 Custom 16 Channel Logic Probe Bare PCB w/ Tray and Cable Bundle

Description

This is a custom Rigol MSO5000 logic probe. The line drivers are SN65LVDS1DBVRG4. They have 5V tolerant inputs. High level is 2-5V. Low level is 0-0.8V. The voltage regulator is an LDO type part.
As you can tell from the photos, this probe should work best at up to around 100 MHz when used with the MSO5000 oscilloscope. There appears to be an increasing amount of jitter past that point. The cutoff was slightly above 475 MHz. I was using a sine waveform biased to be between the transition points. You may have a better experience if you drive it harder. If you have some other use for this board, the design should be usable far past that. Up to at least 500 MHz. The line drivers are 600 MHz parts.
The listing is only for one 50 pin 2.54mm pitch ribbon cable and one of the probe PCBs double sided taped to a 3D printed tray.
If you just want the tray you can get it here:
https://www.thingiverse.com/thing:4729988